![]() Google Corel Photo paint tutorials, and you get a good list. There are some good version 8, 9 and 10 tutroials on the web though. I am sorry I cant give you more precise directions, as I haven't used version 9 in so long now, it is hard to remember which options it had and which it didnt. ![]() This will help insure that the two are not blending somewhere along the line - especially with a transparent background - it can be hard to see any "smoothing" areas that the mask might pick up. The biggest two things you can do is select a contrasting background color instead of no background, and get that logo object duplicated, and have a distinct background and a seperate logo. ![]() These tips should get you a much cleaner final output. This will cut off the outter most layer of pixels from the mask, and cut your logo as close as possible to ensure no background "artifacts". If you can get away with it, you would be better off REDUCING the mask by 1 pixel (inside). You would be better off with 0 transparency, and 0 feathering. Both have had good luck for me in the past.ģ.) When you create your mask around the object, try not to feather it, as this gives a semi transparent edge to the mask. Possibly even something in the reds.Ģ.) when you export your gif, be sure to select the "optimized" or "adaptive" color pallete choices. Also, make sure your background has no variations onf the "blue" pallete - go with something with a very low blue content - something contrasty and opposite side of the color wheel - yellowish if I have to guess (but be careful of any whites). This can also help make your pallette selective - if you begin the new layout with an 8bit pallete. ![]() Sometimes pasting this object into a new layout can help with unwanted jaggies. The second way would be a combination of things.ġ.) make a second copy of your completed logo. This way is not as elegant if you change web backgrounds, or if you put it on various pages with different colors. The first is to make the background match the color of your web page. RE: Object and Background Cosmiccradle (TechnicalUser) Hope this gets you pointed in the right direction. Mask > Create > Mask From Object (depending on your version). The easiest way to do this is to select your object, then create a mask from the object before starting your export. If the background is a blended color, it may pick up some of the color in your logo as well. Then you can select that color to set as transparent. Otherwise, you may have to set an obscure color for the background before you begin the export (preferably one completely outside the range of colors of your logo). The easiest way is to have created a mask of the object, then you can select the mask for transparency. After the color options, and dithering, smoothing etc choices, a final option for. GIF, you will have seen the prompt tell you that all images will be combined with background, and the background will most likely have changed color. In either case, assuming you are to the point of exporting as. CPT file to begin with (if you ahvent already done so), that way you can always come back to this step before the export, incase something goes wrong. GIF dialogue box (unless it is really old).įor starters I reccomend saving your new logo as a. If you are using an older version, there is a more manual way of doing this, but will still bring up the. Depending on your version, there may be an "Export for Web" or "Web Image Optimizer". If you are "combining objects with background" manually, before exporting, avoid that step. I am not sure if you are using the "export" command to "attach" the image to the background.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |